24C128 DATASHEET PDF

24C Datasheet, 24C 16kbyte Serial SMD EEPROM Datasheet, buy 24CSMD. 24C FEATURES Extended Power Supply Voltage Single Vcc for Read and Programming (Vcc to V) Low Power (Isb @ V) Extended I²C Bus, 2-Wire. Product Support – Data sheets and errata, application notes and . Microchip products meet the specification contained in their particular Microchip Data Sheet .

Author: Gushura Vozilkree
Country: Kazakhstan
Language: English (Spanish)
Genre: Business
Published (Last): 4 March 2006
Pages: 163
PDF File Size: 9.49 Mb
ePub File Size: 5.81 Mb
ISBN: 601-3-41504-811-5
Downloads: 43747
Price: Free* [*Free Regsitration Required]
Uploader: Fenrikasa

So don’t add any. For example, at KHz, with 70 pf, you should use a resistor no larger in value than 4K.

Hope that CCS had the software i2c working with vs. The users were the Beta testers unknowingly,: Is this your very first project, or have you made other projects work first, such as blinking a LED, etc. Sat Mar 01, 4: If you had the chip that has 3 chip-enable lines, then dstasheet would be a “-BBN6”. C sample driver should work OK. Is this your very first project, or have you made other: It’s much better to go for signal integrity.

  ERNEST GINTER ZIVETI BEZ BOLESTI PDF

I am not an expert user and was hoping to able to use this driver instead of writing my own code. Then you can refer to their graph in Figure 3, and see the maximum value of pull-up resistor that you can use.

Download Datasheet for Various electronic components, Modules and Kits

It states on page 3, that they must be connected to Vcc or GND. The users were the Beta testers unknowingly, until they figured it out. Are you using ICD?

But the chip will not initialise. So I can’t tell you if there was a problem for sure.

24C128 PDF Datasheet浏览和下载

Especially, a common GND between: Once i put the pull up resistors in it started to work. For pf, the largest resistor: I don’t even have records for the Beta versions. What version of the CCS compiler do you have?

In your case, you should connect them to GND. Do you have proper connections to Vcc and GND, for both: But this is really a non-issue in most designs. I am tring to use an ST M supplier farnell calls it 24C external eeprom 241c28 with the So I can’t tell you if there was a problem: I have looked at the data sheet for the M, and it looks like the Has anybody else encountered and fixed this problem?

  ANJANEYA DANDAKAM IN TELUGU PDF

24C ATMEL datasheet & applicatoin notes – Datasheet Archive

That is the correct data sheet for a MBN6. It doesn’t represent capacitors that you’re supposed to add.

You should write very: GND, Vcc, or un-connected? All times are GMT – 6 Hours.

You need a pull-up resistor on SDA: Display posts from previous: