Steam humidifier Condair CP2 Technical Documentation EN Contents 1 2 3 4 Bekijk en download hier de handleiding van Condair CP2 Luchtbevochtiger- Luchtontvochtiger (pagina 35 van 56) (English). Ook voor ondersteuning en. Bekijk en download hier de handleiding van Condair CP2 Luchtbevochtiger- Luchtontvochtiger (pagina 13 van 56) (English). Ook voor ondersteuning en.

Author: Tygomi Branris
Country: Georgia
Language: English (Spanish)
Genre: Environment
Published (Last): 7 June 2015
Pages: 228
PDF File Size: 4.12 Mb
ePub File Size: 15.60 Mb
ISBN: 365-8-19291-938-9
Downloads: 57582
Price: Free* [*Free Regsitration Required]
Uploader: Voodoomi

M M3 or M4. No sensor signal present, humidity sensor defective. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan condqir grootte per email. Abonneren Abonneer u voor het ontvangen van emails voor uw Condair CP2 condair cp2 By submitting a question, you confirm your agreement with user agreement.

Condair CP2

Disconnect steam humidifier from electricity supply: Heavily calcified parts, e. Before you start the electrical installation, check whether the CP2-chip is installed. During the drainage process, the drain valve 6 is opened. Condair LS live steam humidifier Economic live steam humidification using a building’s existing steam network to deliver dry steam to a duct or AHU. You are on the All. Then switch off the unit switches on all steam humidifiers.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. CP2-chips for individual units cannot be used condaur multiple units and CP2-chips for multiple.

Wait until the steam cylinder is empty approx. Inspect steam and condensate hoses for cracks and to see that they are correctly attached, replace faulty hoses.

The fan units are delivered with: If steam was produced until shortly before switching off, the steam conndair will be hot. Warning danger of death! Click here for cndair docs. The various accessories humidistats, water filter, etc. Operation of the equipment in the intended manner requires that all the information in these instructions is observed in particular the safety instructions.


Main contactor jammed in activated position.

When deciding on the length and layout of the hose, it should be noted that the steam hose may become somewhat shorter with progressive ageing. Water drain The water drainage is effected without pressure. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft.

Only use CP2-chips with the same serial number in the basic unit of a model. If the designations match, place the CP2-chip in the control print with. The message must not condair cp2 more than symbols.

The Condair CP2 is operated with mains voltage.

The moment the sensor comes in contact with water, the inlet valve closes. Such systems always require a PI-controller. Do the details on the rating plates for heating and control voltage match the relevant network voltage? Before putting the unit into operation, the siphon of the condensate hose must be filled with water. Warning – danger of damage! The steam cylinder must not be removedbefore removing the inlet valve. Steam line with fixed piping For steam lines with fixed piping, the same instructions apply to the laying of the piping as already described.

Release hose clamp and detach filling hose.

Water conductivity too low for type of steam cylinder. Use original Condair condensate hose exclusively.


Bedienungsanleitung Condair CP2 (Seite 11 von 56) (Englisch)

Use only temperature-resistant installation materials! Drill holes in accordance with diagram and cindair the supplied plastic plugs. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. If possible, the steam distribution pipes should be installed on the pressure side of the duct max.

The installation of the filter valve should be made as close as possible. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres conadir of is uw mailbox te vol. The yellow LED blinks.

Parouvlazhnitel Condair CP2

If the steam distribution pipes are installed on the suction side of the duct, the maximum vacuum must not exceed Pa. Subsequently, the drain pipe is connected via siphon to condair cp2 waste. Stel uw vraag in het forum. The humidity sensor A1 is preferably located in the exhaust air duct or in the room itself.

Malfunctions relating to the electrical installation must only be repaired by authorized personnel. Remove carefully electrodes by lifting upwards. U ontvangt de handleiding per email binnen enkele minuten.

The outlet orifices should always point upwards and at right angles to the airflow. Antwoorden worden ook per e-mail naar abonnees gestuurd. Water conductivity too high for type of steam cylinder. Condair CP2 F30 1.