The DAC is an advanced CMOS/Si-Cr 8-bit multiplying. DAC designed to interface directly with the , ,. , Z80®, and other popular. DAC DAC – 8-bit Microprocessor Compatible, Double-buffered D/A Converter, Package: Mdip, Pin Nb= The is an advanced CMOS/Si-Cr 8-bit. DAC Technical Data, DAC 8-bit D/A Convertor Datasheet, buy DACLCN.
|Published (Last):||17 November 2014|
|PDF File Size:||17.66 Mb|
|ePub File Size:||2.52 Mb|
|Price:||Free* [*Free Regsitration Required]|
DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0.
All these control pins need to be setup appropriately as mentioned dac083 for successful DAC conversion of the device. Now for understanding the working let us consider the example application circuit given in the datasheet. Pin Configuration DAC is a twenty pin device and description for each pin is given below.
DAC Technical Data
The device is available in the market for low cost and can be easily worked with. DAC takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output.
The device is specifically designed for it to be interfaced directly with the,Z80, and other popular microprocessors. This analog signal is the current quantity that is directly proportional to the input digital value and this current parameter needed to be converted in to voltage parameter for further use.
DAC Pinout, Features & Datasheet
This op-amp circuit is called current-to-voltage converter. Submitted by admin on 21 November The chip is designed with CMOS technology to achieve low power consumption and low output leakage current errors.
The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved. Double buffering of the device allows outputting a voltage corresponding to one digital word while holding dataeheet next digital word. The design also includes special circuitry that provides TTL logic input voltage level compatibility.
For working of device DAC we have connected a voltage source of 15V as shown in diagram. DAC IC basically used in applications where an 8 bit digital data needed to be converted to analog value. TL — Programmable Reference Voltage.
So to convert the current parameter in to datwsheet parameter we will use op-amp circuit as shown in circuit diagram. We can use the circuit to develop applications without worry as the circuit is tested working.
So the device is used for converting 8 bit parallel digital data input datasheef analog signal output. This also permits the simultaneous updating of any number of DACs.