D-Link DGL User Manual. Section – Configuration. The setting can be selected to allow the DGL to choose the channel with the. The following instructions for setting this up depends on whether you are using View and Download D-Link DGL – GamerLounge Xtreme N Gaming Router Wireless user manual online. Gaming Router. DGL – GamerLounge.

Author: Dujinn Dilar
Country: Gabon
Language: English (Spanish)
Genre: Video
Published (Last): 2 June 2004
Pages: 378
PDF File Size: 1.98 Mb
ePub File Size: 15.50 Mb
ISBN: 505-4-33057-625-6
Downloads: 11825
Price: Free* [*Free Regsitration Required]
Uploader: Kazijin

There are three basic methods to accomplish this: Frame Relay Network causes the measured uplink speed to be reported slightly lower than before on such connections, but gives much better results. There are pre-defined virtual services already in the table.

Check Email Notification of Newer Firmware Version to have the router send an email when there is a new firmware available. This section will list any rules that are created. Warranty Period and is subject to the same limitations and exclusions. Wizard to quickly configure your router. Enable For most mankal, the priority classifiers ensure the right priorities and specific Dgl-4050 Rules are not required.

Wireless Wireless The wireless client table displays a list of current connected wireless clients. Protocol – Select the protocol. The higher the number the lower the priority. Xgl-4500 Enter a maximum idle time during which the Internet Time: Connect an Ethernet cable in one of the LAN ports of the router and connect it to your other router.


What Is Wireless Why. Click Upload to complete the firmware upgrade. Wireless Security Setup Wizard Automatically:. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Refer to the Networking. Please contact the D-Link office in your region for firmware updates that are compatible with your D-Link product.


D-Link may, at its option, replace the defective Hardware or any part thereof with any reconditioned product that D-Link reasonably determines is substantially equivalent or superior in all dgl–4500 respects to the defective Hardware. Comments to this Manuals Your Name.

Dlink DGL-4500 User Manual

Make sure the firmware you want to use is on the local hard drive of the computer. Please check the D-Link support site for firmware updates at http: Add Website Select Allow or Deny. Click Save to save the access control rule. Check this box to reduce the guard interval time therefore increasing the data capacity.

Page 46 Enter the following information and then click Next to continue. Only – Select only if all of your wireless clients are Wait about 30 seconds for the router to boot. Preface Preface D-Link reserves the right to revise this publication and to make changes in the content hereof without obligation to notify any person or organization of such revisions or changes. The public port is the port seen from the Internet side, and the private port is the port being used by the application on the computer within your local network.

When you first set up the router, Wi-Fi protection is disabled and unconfigured. The software is no longer needed and will not work through a router. Inbound Filters Inbound Filter This section will list any rules that are created.

Address – Enter the IP address of the computer you want to apply the rule to.

D-Link DGL-4500 – GamerLounge Xtreme N Gaming Router Wireless User Manual

The Ping Test is used dgl-45500 send Ping packets to test if a computer is on the Internet. Start – Enter the starting port number. Any settings that have not been saved will be lost, including any rules that you have created. If you are using third party software to set up Wi-Fi Protection, carefully follow the directions.


Environmental conditions will adversely affect wireless signal range. This is determined by your ISP. Some dgl4-500 cable or DSL modems may require you to set the port speed to 10Mbps.

Enter a time in hours. Name — Enter a name to identify the rule or select one using the drop-down list to the right.

Enter the IP address of the computer on your local network that you want to allow the incoming service to. Click on Check Online Now for Latest Firmware Version to find out if there is an updated firmware; if so, download the manuzl firmware to your hard drive. Click on Browse to locate the firmware file to be used for the update.

Inbound Filter This section will list any rules that are created. Select your time zone from the drop-down menu and then click Next to continue. Position dgl-500 devices so that the number of walls or ceilings is minimized. You may click Setup. Step 1 Open a web browser and type the IP address of the D-Link gaming router in the address bar default is You can find software updates and user documentation on the D-Link website as well as frequently asked questions and answers to technical issues.