Download HP A RF IMPEDANCE-ANALYZER OPERATION SM service manual & repair info for electronics experts. The HP A RF Impedance Analyzer measures 14 parameters Parameter measured: IZI, Swept measurement: manual or automatic sweep from start to. Agilent A Test Fixture. Operation and Service Manual. Third Edition. Agilent Part No. February Printed in Japan.

Author: Dagore Braramar
Country: Haiti
Language: English (Spanish)
Genre: Sex
Published (Last): 4 September 2009
Pages: 310
PDF File Size: 1.15 Mb
ePub File Size: 10.73 Mb
ISBN: 928-4-39864-411-7
Downloads: 22039
Price: Free* [*Free Regsitration Required]
Uploader: Meztihn

Message 4 of 6. I have worked with the A and, as I recall, the commands are nothing like any other instrument I have seen.

Keysight / Agilent A – In Stock, We Buy Sell Repair, Price Quote

Message 5 of 6. Should I be looking at doing it with LabView or something else? I went through the manual before, but when I saw their GPIB section, the strings were so convoluted and so unlike anything I’ve ever seen before that I assumed it was referring to something different.

If not, what would creating a driver for it entail?


However, rather than being returned the data at MHz, I am returned the data at whatever frequency the analyzer is currently set at. Message 6 of 6. Most Active Software Boards: I think the would probably take manial old commands, but the ALSO has new commands.

Guess you never know until you try!

IIRC, the sweep parameters were something like this: In particular, after setting up and initiating the instrument, I am initiating the measurement and reading it as follows: You really need the manual. Message 2 of 6. Would you mind posting the code you used on mxnual A?

Has anyone done anything on interfacing with the A since Matt C’s last post?

A RF IMPEDANCE ANL [Obsolete] | Keysight (formerly Agilent’s Electronic Measurement)

When I gave it a try, though, it worked fine. In particular, after setting up and initiating the instrument, I am initiating the measurement and reading it as follows:. The forums emoticons took over for a bit there. I am able to communicate with the device through the GPIB interface, and bp4191a also able to retrieve information.



Matt – you’re right, the commands for the A are completely different from the – probably because of its mqnual.

I suspect that this difference might be causing my problems.

It’s 84MB, so I hope you have a fast link. In the code above, MHz is an arbitrary frequency. Message 3 of 6. Good luck with it H4p191a, that last line of code there is supposed to read: Message 1 of 6. Accepted by topic author Matt C.

Agilent / HP 4191A RF Impedance Analyzer

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Thanks for your help guys. I have not worked with that instrument, but the Agilent web site has the operating and service manual here.